d2:power_supply
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
d2:power_supply [2016/02/04 20:07] – add include section Ben Luey | d2:power_supply [2017/10/12 00:45] – [Back panel I/O] Michael Radunsky | ||
---|---|---|---|
Line 62: | Line 62: | ||
**Power I/O (9-pin D-sub)** | **Power I/O (9-pin D-sub)** | ||
+ | <WRAP center round important 60%> | ||
+ | Never connect this D2-005 Power Supply to a device when it is switched on and supplying power. Always turn off the D2-005, make connections to the device, and then re-energize the D2-005. | ||
+ | </ | ||
The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit. The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels. | The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit. The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels. |
d2/power_supply.txt · Last modified: 2023/02/01 21:10 by 127.0.0.1