User Tools

Site Tools


d2:power_supply

This is an old revision of the document!


D2-005 Power Supply

Power Supply

Model No. D2-005

Document Revision: 1

Document Last Updated on 2021/08/26 14:26

Please read Limited Warranty and General Warnings and Cautions prior to operating the D2-005.

Description

The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules.

Purchase Includes

  • D2-005 Power Supply
  • VPN00464 Power Cord

Absolute Maximum Ratings

Note: All modules designed to be operated in laboratory environment

Parameter Rating
Environmental Temperature >15°C and <30°C
Environmental Humidity <60%
Environmental Dew Points <15°C

Specifications

Units
Current Limit
<html> &nbsp;&nbsp; </html>+15V 1.5 A
<html> &nbsp;&nbsp; </html>-15V 1.5 A
<html> &nbsp;&nbsp; </html>+5V 6 A
Output Regulation 0.05 %

Inputs, Outputs, and Controls

Fig. 1: Schematic drawing of the front and back panels of the D2-005

Monitor Section

The monitor section contains three blue status LEDs indicating proper voltage on the +15,-15, and 5V power lines. If there is a voltage sag on any of the power lines, the blue status LED will turn off.

Back panel I/O

Power I/O (9-pin D-sub)

Never connect this D2-005 Power Supply to a device when it is switched on and supplying power. Always turn off the D2-005, make connections to the device, and then re-energize the D2-005.

The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit. The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels. The pin outs are shown in the following figure:

d2/power_supply.1507769115.txt.gz · Last modified: 2021/08/26 14:26 (external edit)