Differences

This shows you the differences between two versions of the page.

--- d2:power_supply [2014/07/31 01:37] – external edit 127.0.0.1
+++ d2:power_supply [2017/10/12 00:45] – [Back panel I/O] Michael Radunsky
@@ Line 17: / Line 17: @@
 The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules.
+=====Purchase Includes=====
+  * D2-005 Power Supply
+  * VPN00464 Power Cord
 ===== Absolute Maximum Ratings =====
@@ Line 55: / Line 62: @@
 **Power I/O (9-pin D-sub)**
+<WRAP center round important 60%>
+Never connect this D2-005 Power Supply to a device when it is switched on and supplying power. Always turn off the D2-005, make connections to the device, and then re-energize the D2-005.
+</WRAP>
 The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit.  The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels.  The pin outs are shown in the following figure: