Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision |
waveguide:manual [2016/03/02 22:16] – [Operation] Michael Radunsky | waveguide:manual [2021/08/26 15:26] (current) – external edit 127.0.0.1 |
---|
<WRAP right round box 550px><imgcaption pinout| Pin-Out for the LC-105 connection to the optical head.>{{ :waveguide:manuals:3_pin_out.png?500}}</imgcaption></WRAP> | <WRAP right round box 550px><imgcaption pinout| Pin-Out for the LC-105 connection to the optical head.>{{ :waveguide:manuals:3_pin_out.png?500}}</imgcaption></WRAP> |
| |
The cable plugs into the LS-105 with a push connector (female bulkhed connector: [[http://www.digikey.com/product-detail/en/hirose-electric-co-ltd/HR10A-10R-10SB/HR359-ND/279920|Hirose HR10A-10R-10SB]]; male cable end: [[http://www.digikey.com/product-detail/en/hirose-electric-co-ltd/HR10A-10P-10P/HR116-ND/40909|Hirose HR10A-10P-10P]]). To remove the cable simply pull from the metal housing on the end of the connector. The connector pin-out is shown in <imgref pinout>. The clip leads are labeled appropriately. | The cable plugs into the LS-105 with a push connector (female bulkhead connector: [[http://www.digikey.com/product-detail/en/hirose-electric-co-ltd/HR10A-10R-10SB/HR359-ND/279920|Hirose HR10A-10R-10SB]]; male cable end: [[http://www.digikey.com/product-detail/en/hirose-electric-co-ltd/HR10A-10P-10P/HR116-ND/40909|Hirose HR10A-10P-10P]]). To remove the cable simply pull from the metal housing on the end of the connector. The connector pin-out is shown in <imgref pinout>. The clip leads are labeled appropriately. |
| |
===Prototype EO Scanner Optical Head=== | ===Prototype EO Scanner Optical Head=== |