Differences

This shows you the differences between two versions of the page.

--- slice:dhv:api [2020/06/09 23:43] – [Query Output Voltage: OUTVOLT?] Michael Radunsky
+++ slice:dhv:api [2021/12/15 20:57] – external edit 127.0.0.1
@@ Line 23: / Line 23: @@
 ^ Stop Bits     |  1     |
 ^ Flow Control  |  None  |
 To perform an operation, an ASCII-based text message is first constructed from a command and its arguments, and then the message is transmitted to the SLICE instrument through the COM port. The following rules apply:
@@ Line 35: / Line 34: @@
   - [Float] refers to a floating point argument that has a decimal point in its value.
- <WRAP important>Changes effected by issuing a serial command from this API are not permanently stored in non-volatile memory until you issue a SAVE command. Configuration changes without the SAVE command will be lost with power cycling. The Save command stores the entire configuration and so several configuration changes can be implemented and then a single SAVE command could be issued.
+ <WRAP round important 100%>Changes effected by issuing a serial command from this API are not permanently stored in non-volatile memory until you issue a SAVE command. Configuration changes without the SAVE command will be lost with power cycling. The Save command stores the entire configuration and so several configuration changes can be implemented and then a single SAVE command could be issued.
 </WRAP>
@@ Line 72: / Line 71: @@
 ==== SCPI device information: *IDN? ====
-<WRAP center round important 100%>Replace [asterix] with a *</WRAP>
+<WRAP center round important 100%>Replace [asterisk] with a *</WRAP>
-<function=ICEfunc|0=[asterix]IDN?&1=:None;&2=Vescent Photonics, [serial#], S-V1.74, DHV-V1.18&-1>
+<function=ICEfunc|0=[asterisk]IDN?&1=:None;&2=Vescent Photonics, [serial#], S-V1.74, DHV-V1.18&-1>
 Returns SCPI device information. Running System Controller firmware version 1.74 and DHV firmware version 1.18.
 ----