slice:dhv
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
slice:dhv [2022/03/15 18:38] – external edit 127.0.0.1 | slice:dhv [2024/04/08 16:05] – Thomas Bersano | ||
---|---|---|---|
Line 226: | Line 226: | ||
< | < | ||
- | ====Choosing | + | ====Choosing |
- | On newer models of the SLICE-DHV, a feature was added which allows the user to switch the Modulation Mode of their unit between Current Limited, and Full Bandwidth. These two modes control the amount of drive current which can be sent through the output op-amp to modulate the load attached to HV out. In Full Bandwidth mode, the current through the op-amp is not limited, giving the SLICE-DHV a larger modulation bandwidth. The drawback, however, is that the output op-amp will occasionally go into thermal shutdown, or show distortions when driven especially hard, or with larger loads. In Current Limited mode, on the other hand, the output op-amp is throttled slightly to prevent the issues | + | On newer models of the SLICE-DHV, a feature was added which allows the user to switch the Modulation Mode of their unit between Current Limited, and Full Bandwidth. These two modes control the amount of drive current which can be sent through the output op-amp to modulate the load attached to HV out. In Full Bandwidth mode, the current through the op-amp is not limited, giving the SLICE-DHV a larger modulation bandwidth. The drawback, however, is that the output op-amp will occasionally go into thermal shutdown, or show distortions when driven especially hard, or with larger loads. In Current Limited mode, the output op-amp is throttled slightly to prevent the thermal shutdown and distortions |
- | It is recommended to use the Full Bandwidth modulation mode if in the small signal regime (G=1 output mode, < 20 Vpp modulation), | + | It is recommended to use the Full Bandwidth modulation mode if in the small signal regime (G=1 output mode, < 20 Vpp modulation), |
==== Setting the Voltage Limit ==== | ==== Setting the Voltage Limit ==== | ||
The user can set the maximum voltage output on a given channel so as not to exceed the rated maximum for their device. | The user can set the maximum voltage output on a given channel so as not to exceed the rated maximum for their device. |
slice/dhv.txt · Last modified: 2024/04/09 21:54 by Thomas Bersano