slice:dhv
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:dhv [2020/05/25 21:37] – [System Settings] Kurt Vogel | slice:dhv [2020/08/07 22:22] – [Setting the Voltage Limit] Michael Radunsky | ||
---|---|---|---|
Line 232: | Line 232: | ||
The user can set the maximum voltage output on a given channel so as not to exceed the rated maximum for their device. | The user can set the maximum voltage output on a given channel so as not to exceed the rated maximum for their device. | ||
+ | This voltage limit circuit in the DHV hardware limits the voltage (including the modulation input) to the user defined limit when using the G=20 V/V mode. However, this hardware limit will not cap the modulation input in the G=1 V/V. Therefore, the output with a +10 V modulation input can exceed the user defined limit by 10 V when operating in the G=1 V/V mode. | ||
==== Setting the Bias Voltage ==== | ==== Setting the Bias Voltage ==== | ||
To set the bias voltage about which the SLICE-DHV will operate on a given channel, touch the DC Bias [V] field on the Home screen. | To set the bias voltage about which the SLICE-DHV will operate on a given channel, touch the DC Bias [V] field on the Home screen. | ||
Line 350: | Line 351: | ||
- | ===== Using the Host GUI ===== | + | ===== Using the PC Host GUI ===== |
Coming soon, please check back later. | Coming soon, please check back later. | ||
===== Firmware Update ===== | ===== Firmware Update ===== |
slice/dhv.txt · Last modified: 2024/04/09 21:54 by Thomas Bersano