slice:dhv
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:dhv [2020/05/25 21:28] – [Internal Ramp Function] Kurt Vogel | slice:dhv [2020/05/25 21:39] – [Using the Host GUI] Kurt Vogel | ||
---|---|---|---|
Line 271: | Line 271: | ||
- | ==== Modulation/ | + | ==== Modulating |
- | The user can input an analog voltage signal to control the output of the SLICE-DHV. Before introducing a control | + | The user can input an analog voltage signal to control the output of the SLICE-DHV. Before introducing a modulation |
- | The default modulation input is the SMA connector on the rear panel (bubble 3, <imgref back> | + | The default modulation input port is the SMA connector on the rear panel (bubble 3, <imgref back> |
- | While similar in performance, | + | While similar in performance, |
Line 332: | Line 332: | ||
< | < | ||
- | === User Interface Appearance | + | === Screen Brightness and Volume Adjustment |
From this screen, adjustments to the brightness of the screen and the volume of the audio feedback can be made. | From this screen, adjustments to the brightness of the screen and the volume of the audio feedback can be made. | ||
=== Input Impedance === | === Input Impedance === | ||
- | Change the input impedance of the two front-panel input ports. | + | Change the input impedance of the two front-panel input ports. |
=== SLICE Firmware === | === SLICE Firmware === | ||
Line 350: | Line 350: | ||
- | ===== Using the Host GUI ===== | + | ===== Using the PC Host GUI ===== |
Coming soon, please check back later. | Coming soon, please check back later. | ||
===== Firmware Update ===== | ===== Firmware Update ===== |
slice/dhv.txt · Last modified: 2024/04/09 21:54 by Thomas Bersano