slice:dhv
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| slice:dhv [2020/05/25 21:24] – [Setting the Bias Voltage] Kurt Vogel | slice:dhv [2020/05/25 21:28] – [Internal Ramp Function] Kurt Vogel | ||
|---|---|---|---|
| Line 245: | Line 245: | ||
| The SLICE-DHV has an internal ramp function for sweeping the voltage output. The ramp is a sawtooth wave. | The SLICE-DHV has an internal ramp function for sweeping the voltage output. The ramp is a sawtooth wave. | ||
| - | To set the repetition | + | To set the sweep rate((0-30 Hz)) of the ramp, touch the CH 1 (or CH 2) field to see <imgref CH_settings> |
| - | To set the amplitude of the ramp((0-200 V)), touch the Range [V] field on the Home screen and set the ramp amplitude. \\ | + | To set the amplitude of the ramp((0-200 V)), touch the Range [V] field on the Home screen and set the desired |
| To turn on (or turn off) the ramp, touch the Sweep OFF (or Sweep ON) field to see <imgref sweep_ctrl> | To turn on (or turn off) the ramp, touch the Sweep OFF (or Sweep ON) field to see <imgref sweep_ctrl> | ||
slice/dhv.txt · Last modified: 2024/04/09 21:54 by Thomas Bersano