Product Manuals

User Tools

Site Tools

You are here: manuals » slice » dcc
slice:dcc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
slice:dcc [2020/04/29 22:25] – [Specifications] Michael Radunskyslice:dcc [2020/04/29 22:51] – [Connecting to the Laser Diode] Michael Radunsky
Line 203: Line 203:
 The Home screen displays the status of both channels (<imgref home_scr_dcc>).  The data for each channel is arranged vertically.   At a glance, for each channel, I<sub>set</sub>, and Compliance Voltage can be read.  Touching the blue window labelled Voltage [V] will cause this window to toggle from displaying  Compliance Voltage to displaying dissipated Power. The Home screen displays the status of both channels (<imgref home_scr_dcc>).  The data for each channel is arranged vertically.   At a glance, for each channel, I<sub>set</sub>, and Compliance Voltage can be read.  Touching the blue window labelled Voltage [V] will cause this window to toggle from displaying  Compliance Voltage to displaying dissipated Power.
 ==== Connecting to the Laser Diode ==== ==== Connecting to the Laser Diode ====
-The SLICE-DCC requires that the cathode of the laser diode is at ground.+The SLICE-DCC requires that the cathode of the laser diode is at ground (<imgref cath_gnd>).  The anode is connected to the center conductor of the SMA connector on the rear of the SLICE-DCC and the cathode is connected to the sheath. 
 + 
 +<imgcaption cath_gnd|Wiring configuration for laser diode>{{ :slice:dcc:cathode_ground.png?430 |}}</imgcaption>
  
 ==== Setting the Operation Mode ==== ==== Setting the Operation Mode ====
slice/dcc.txt · Last modified: 2024/03/27 21:07 by Thomas Bersano