Differences

This shows you the differences between two versions of the page.

--- slice:dcc [2019/09/24 22:13] – [Error States] Michael Radunsky
+++ slice:dcc [2020/03/07 00:02] – [Specifications] Michael Radunsky
@@ Line 44: / Line 44: @@
   * SLICE-DCC dual-channel Current Controller
   * AC power cord with appropriate wall plug for you location (if known)
-  * Two 6 ft SMA cables
   * One BNC grounding cap for door safety interlock
   * Two keys for lock out
@@ Line 98: / Line 97: @@
 | Control                                                              |  Touch Screen, GUI, Serial commands     |
 | Operation Modes                                                      |  Constant Current\\ Constant Power      |
-| \\ \\ Maximum Current                                                |  200 mA\\ 500 mA\\ 1 A\\ 2 A            |
+| \\ \\ Maximum Current                                                |  200 mA\\ 500 mA\\ 1,000 A\\ 2,000 mA            |
 | \\ \\ Current Noise((Constant Current Mode)) ((rms 10 Hz to 1 MHz))  |  1.5\\ 4\\ 10\\ 15                      |
 | Modulation Bandwidth((3 dB))                                         |  DC to >1 MHz                           |
-| Modulation Depth                                                     |  ±10 mA                                 |
+| Modulation Depth          \\ 200 mA\\ 500 mA\\ 1,000 mA\\ 2,000 mA |  \\ ±100 mA\\ ±250 mA\\ ±500 mA\\ ±500 mA  |
-| Modulation Transfer Function                                         |  1 mA/V                                 |
+| Modulation Transfer Function  \\ 200 mA\\ 500 mA\\ 1,000 mA\\ 2,000 mA |  \\ 1 mA/V \\ 2.5 mA/V \\ 5 mA/V \\ 5 mA/V  |
 | Modulation Input Range                                               |  ±10 V                                  |
 | Current Resolution                                                   |  100 µA                                 |
@@ Line 265: / Line 264: @@
 <imgcaption io_input|Input choice for front-panel input>{{ :slice:dcc:i-o_input_equals_modulation.png?430x254 |}}</imgcaption>
-At present (Aug, 2019), the only input option is a modulation signal.  The SLICE-DCC can respond to a modulation or control signal over a bandwidth of DC to 1 MHz.
+The only input option is a modulation signal.  The SLICE-DCC can respond to a modulation or control signal over a bandwidth of DC to 1 MHz.  Only one of the two modulation input ports (rear-panel SMA, <imgref back>, item 9 or front-panel BNC, <imgref front>, item 2) can be active at any given time.
 ==== Programmable Output ====
@@ Line 295: / Line 294: @@
 Change the input impedance of the two front-panel input ports.  Select either 50 Ω or 1 MΩ.
-=== SLICE-QT Firmware ===
+=== SLICE Firmware ===
 Current firmware versions are reported here.