slice:dcc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:dcc [2019/09/24 22:09] – [Triggering] Michael Radunsky | slice:dcc [2020/02/01 01:21] – [System Settings] Michael Radunsky | ||
---|---|---|---|
Line 44: | Line 44: | ||
* SLICE-DCC dual-channel Current Controller | * SLICE-DCC dual-channel Current Controller | ||
* AC power cord with appropriate wall plug for you location (if known) | * AC power cord with appropriate wall plug for you location (if known) | ||
- | * Two 6 ft SMA cables | ||
* One BNC grounding cap for door safety interlock | * One BNC grounding cap for door safety interlock | ||
* Two keys for lock out | * Two keys for lock out | ||
Line 265: | Line 264: | ||
< | < | ||
- | At present (Aug, 2019), the only input option is a modulation signal. | + | The only input option is a modulation signal. |
==== Programmable Output ==== | ==== Programmable Output ==== | ||
Line 277: | Line 276: | ||
External control of the SLICE-DCC is accomplished via a TTL trigger.((https:// | External control of the SLICE-DCC is accomplished via a TTL trigger.((https:// | ||
=== Trigger Out === | === Trigger Out === | ||
- | The Trigger Out on the back panel of the SLICE-DCC can be programmed to go high if an interlock (key or door) is opened. | + | The Trigger Out on the back panel of the SLICE-DCC can be programmed to go high if an interlock (key or door) is opened. |
< | < | ||
=== Trigger In === | === Trigger In === | ||
Line 295: | Line 294: | ||
Change the input impedance of the two front-panel input ports. | Change the input impedance of the two front-panel input ports. | ||
- | === SLICE-QT Firmware === | + | === SLICE Firmware === |
Current firmware versions are reported here. | Current firmware versions are reported here. | ||
Line 314: | Line 313: | ||
===== Error States ===== | ===== Error States ===== | ||
+ | ==== Interlock Open ==== | ||
If either the key switch is deactivated or the interlock is opened while the system is operating, the SLICE-DCC will stop delivering current and the Enable window will flash red with INTERLOCK displayed (<imgref inter_open> | If either the key switch is deactivated or the interlock is opened while the system is operating, the SLICE-DCC will stop delivering current and the Enable window will flash red with INTERLOCK displayed (<imgref inter_open> | ||
< | < | ||
+ | ==== Open Circuit ==== | ||
If the SLICE-DCC attempts to deliver current, but is unable to do so, it assumes an open circuit fault. | If the SLICE-DCC attempts to deliver current, but is unable to do so, it assumes an open circuit fault. | ||
slice/dcc.txt · Last modified: 2024/03/27 21:07 by Thomas Bersano