Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| slice:dcc [2019/09/13 14:03] – [List of Warning Symbols] Michael Radunsky | slice:dcc [2019/09/24 22:11] – [Triggering] Michael Radunsky |
|---|
| External control of the SLICE-DCC is accomplished via a TTL trigger.((https://en.wikipedia.org/wiki/Logic_level)) 0 to 0.8 V TTL is low and 2 to V<sub>CC</sub> is TTL high. | External control of the SLICE-DCC is accomplished via a TTL trigger.((https://en.wikipedia.org/wiki/Logic_level)) 0 to 0.8 V TTL is low and 2 to V<sub>CC</sub> is TTL high. |
| === Trigger Out === | === Trigger Out === |
| The Trigger Out on the back panel of the SLICE-DCC can be programmed to go high if an interlock (key or door) is opened. The screen shown in <imgref trigger_out> will be reached by touching I/O > Trigger Out. Checking either box will cause the Trigger Out to go high if either the door interlock or the key interlock is opened. | The Trigger Out on the back panel of the SLICE-DCC can be programmed to go high if an interlock (key or door) is opened. The screen shown in <imgref trigger_out> will be reached by touching I/O > Trigger Out. Checking the box will cause the Trigger Out to go high if either the door interlock or the key interlock is opened. |
| <imgcaption trigger_out|Setting an output trigger>{{ :slice:dcc:output_trigger.png?430x254 |}}</imgcaption> | <imgcaption trigger_out|Setting an output trigger>{{ : slice:dcc:trigger_interlock.png?430x254 |}}</imgcaption> |
| === Trigger In === | === Trigger In === |
| The input trigger can be used to turn on or off the current for either or both channels. From any screen, touch I/O > Trigger In. You will be presented with the window in <imgref trigger_in>. Select which channels you wish to control with the incoming trigger. In <imgref trigger_in_2>, current to CH 2 will be disabled if the Trigger In goes high. | The input trigger can be used to turn on or off the current for either or both channels. From any screen, touch I/O > Trigger In. You will be presented with the window in <imgref trigger_in>. Select which channels you wish to control with the incoming trigger. In <imgref trigger_in_2>, current to CH 2 will be disabled if the Trigger In goes high. |
