ice:servo-opls
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ice:servo-opls [2019/11/18 23:34] – [Specifications] Michael Radunsky | ice:servo-opls [2021/05/20 22:40] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 68: | Line 68: | ||
Two numbers control the offset frequency of the ICE-CP1: The divider setting N and the reference frequency. The divider setting N can be set to N=8,16,32 or 64. The reference frequency can be generated internally with a range from 50 - 240 MHz. Or an external frequency reference can be provided (external frequency must be from 32 MHz - 240 MHz). The offset frequency of the laser is given by the following formula: | Two numbers control the offset frequency of the ICE-CP1: The divider setting N and the reference frequency. The divider setting N can be set to N=8,16,32 or 64. The reference frequency can be generated internally with a range from 50 - 240 MHz. Or an external frequency reference can be provided (external frequency must be from 32 MHz - 240 MHz). The offset frequency of the laser is given by the following formula: | ||
- | <WRAP center round box 450px>< | + | <WRAP center round box 260px> **Offset = N * Reference Frequency** </ |
The table below shows the offset range for different values of N and using the internal or external frequency reference. | The table below shows the offset range for different values of N and using the internal or external frequency reference. |
ice/servo-opls.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1