ice:pcb_mechanics
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
ice:pcb_mechanics [2014/07/02 18:23] – [PCB Dimensions] jtshugrue | ice:pcb_mechanics [2021/08/26 15:26] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 22: | Line 22: | ||
</ | </ | ||
===== Thermal Management ===== | ===== Thermal Management ===== | ||
- | Each PCB exposes up to 4 copper tabs to conduct heat out from power dissipating components to an external heat sink. The copper tabs are not electrically isolated, so electrical isolation is **required** at the interface between the heatsink and copper tab. Failure to isolate these tabs will result in malfunction of the ICE module. For electrical isolation with good thermal conductivity, | + | Each PCB exposes up to 4 copper tabs to conduct heat out from power dissipating components to an external heat sink. The copper tabs are not electrically isolated, so electrical isolation is **required** at the interface between the heatsink and copper tab. Failure to isolate these tabs will result in malfunction of the ICE module. For electrical isolation with good thermal conductivity, |
<WRAP center round important 60%> | <WRAP center round important 60%> | ||
The copper tabs **must** be electrically isolated from the heatsink. For electrical isolation with good thermal conductivity, | The copper tabs **must** be electrically isolated from the heatsink. For electrical isolation with good thermal conductivity, |
ice/pcb_mechanics.txt · Last modified: 2021/08/26 15:26 by 127.0.0.1