Product Manuals

User Tools

Site Tools

You are here: manuals » ice » commands » peaklock
ice:commands:peaklock

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
ice:commands:peaklock [2017/05/04 17:35] – Michael Radunskyice:commands:peaklock [2018/11/27 01:33] – Michael Radunsky
Line 1: Line 1:
 ====== Peak Lock and Current Controller Command Set ====== ====== Peak Lock and Current Controller Command Set ======
  
-List of commands for the ICE Quad Temperate Controller. Please see [[ice:commands:lasercurrent|Common Laser Controller Command Set]] for commands relating to the laser controller.+List of commands for the ICE Peak Lock Servo. Please see [[ice:commands:lasercurrent|Common Laser Controller Command Set]] for commands relating to the laser controller.
  
 <function=ICEfunc|0=Phase?&2=58&3=32> <function=ICEfunc|0=Phase?&2=58&3=32>
Line 111: Line 111:
  
 <function=ICEfunc|0=RampNum&1=I:NUMBER:100&2=100&3=54> <function=ICEfunc|0=RampNum&1=I:NUMBER:100&2=100&3=54>
-Sets the number of data points to be acquired during the ramp. Number of data points is also the number of steps for the ramp. Number of data points to calculated by the following formula:+Sets the number of data points to be acquired during the ramp. Number of data points is also the number of steps for the ramp. 
  
 <html></div></html> <html></div></html>
ice/commands/peaklock.txt · Last modified: 2023/11/30 21:32 by 127.0.0.1