ice:commands:opls
This is an old revision of the document!
Offset Phase Lock and Current Controller Command Set
List of commands for the ICE Offst PHase Lock and Current Controller. Please see Common Laser Controller Command Set for commands relating to the laser controller and Common Commands to all ICE Slave Boards for generic slave board commands.
Arguments:
No Arguments Taken
Example:
8
I2C Command Number: 32
Description
Returns the value of the N divider. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Set the value of the N divider. Valid settings are 8,16,32 and 64. Returns output from N? command. <html></div></html>
Arguments:
No Arguments Taken
Example:
On
I2C Command Number: 34
Description
Returns whether the error signal is being inverted or not. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Turns on or off inverting the error signal. Effectively changes the gain sign of the loop and whether the slave laser will be to the red or blue of the master laser. Returns output of Invert? Command. <html></div></html>
Arguments:
No Arguments Taken
Example:
Off
I2C Command Number: 36
Description
Returns if the internal reference oscillator is active (as opposed to using an external reference). <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Enables or disables using the internal reference (instead of external reference). Returns output of IntRef? command. <html></div></html>
Arguments:
No Arguments Taken
Example:
162875345.34
I2C Command Number: 38
Description
Returns the internal reference’s oscillator’s frequency in Hz. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Sets the internal reference oscillator’s frequency to FREQ, where FREQ is a the frequency in Hz. Returns the output of the IntFreq? command. <html></div></html>ice/commands/opls.1389651086.txt.gz · Last modified: 2021/08/26 14:26 (external edit)