ice:commands:lasercurrent
This is an old revision of the document!
Common Laser Controller Command Set
List of common commands for controlling the laser controller in both the Peak Lock Servo and Peak Lock Servo & Current Controller and the Offset Phase Lock Servo & Current Controller.
Arguments:
No Arguments Taken
Example:
On
I2C Command Number: 16
Description
Returns the status of the laser (on, off or fault). <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Turns the laser on or off. Valid arguments are ON or OFF. Only turns the laser on when no fault / interlock issues. Returns the output from the Laser? command. <html></div></html>
Arguments:
No Arguments Taken
Example:
147.6
I2C Command Number: 18
Description
Returns the laser current setpoint (in mA) for how much current will flow through the laser when the laser is on. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Sets the setpoint laser current (in mA) to CURRENT. Returns the output from the CurrSet? command. <html></div></html>
Arguments:
No Arguments Taken
Example:
180.0
I2C Command Number: 20
Description
Returns the current limit (in mA) for the maximum current allowed to flow through the laser when the laser is on. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Sets the maximum laser current to CURRENT. Returns the output from the CurrLim? command. Note: If Laser Current is set above new current limit value, then current setpoint is lowered to new current limit value. <html></div></html>ice/commands/lasercurrent.1387233899.txt.gz · Last modified: 2021/08/26 14:26 (external edit)