ice:commands:common
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
ice:commands:common [2013/12/06 23:35] – created Ben Luey | ice:commands:common [2023/11/30 21:29] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 3: | Line 3: | ||
This following commands are common to all slave boards: | This following commands are common to all slave boards: | ||
- | < | + | < |
- | Enumerate device. Returns the device ID, firmware revision (major and minor), hardware revision, command set revision, | + | Enumerate device. Returns the device |
< | < | ||
- | < | + | < |
- | Resets the ICE board to initial power on conditions. | + | Resets the ICE board to initial power on conditions. If SYSTEM is 0, resets to the saved EEPROM settings. If SYSTEM is 1, resets to factory default settings. |
< | < | ||
- | < | + | < |
Returns the status (Ready, Busy) of the ICE board. | Returns the status (Ready, Busy) of the ICE board. | ||
< | < | ||
+ | |||
+ | < | ||
+ | Tells ICE board to abort the long-running command it is currently executing. | ||
+ | < | ||
+ | |||
+ | < | ||
+ | Reads the specified data block from the ICE board data buffer. Returns 8 bytes starting at BLOCK address. | ||
+ | See individua ICE board for structure of the data. | ||
+ | < | ||
+ | |||
+ | < | ||
+ | Saves the board’s current settings into EEPROM. Unsaved changes will be lost when the board is powered off. Returns SUCCESS or FAIL. | ||
+ | < | ||
+ | |||
+ | < | ||
+ | Returns various versions of the board (hardware, firmware) and serial number in raw form. Use the Master' | ||
+ | < | ||
+ | |||
+ | |||
ice/commands/common.txt · Last modified: 2023/11/30 21:29 by 127.0.0.1