ice:commands:common
This is an old revision of the document!
Common Commands to all ICE Slave Boards
This following commands are common to all slave boards:
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Enumerate device. Returns the device ID, firmware revision (major and minor), hardware revision, command set revision, and number of supported commands. In general, this command is only used internally by the Master board. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Resets the ICE board to initial power on conditions. <html></div></html>
Arguments:
No Arguments Taken
Example:
I2C Command Number:
Description
Returns the status (Ready, Busy) of the ICE board. <html></div></html>ice/commands/common.1386372934.txt.gz · Last modified: 2021/08/26 14:26 (external edit)