Differences

This shows you the differences between two versions of the page.

--- ffc:cm:api-ld [2021/12/07 22:27] – external edit 127.0.0.1
+++ ffc:cm:api-ld [2022/03/29 17:19] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-=====FFC-CM Laser Driver API=====
+=====FFC-CM Fiber Laser Driver API=====
-Placeholder page for the Laser Driver API page.
+====Links====
+* **Quick-Start Guides**
+    * [[ffc:cm:quickstart|FFC-CM Quick Start]]
+*  **Electronics**
+    * [[ffc:cm:manual|FFC-CM Manual]]
+*  **Websites**
+    * [[https://vescent.com/us/ffc-100-frequency-comb.html|FFC-CM web page]]
+    * [[https://github.com/Vescent/FFC_Firmware_Upgrade-and-FPGA-Software-Firmware|Github page for FFC-100 firmware revisions]]
+*  **Downloads**
+    * {{ :ffc:cm:ffc_gen2_laser_driver_command_api_r03.docx |}}
+=====Implementation Instructions=====
+Listed below is the command set for the Application Programming Interface (API) for the FFC-CM Laser Driver boards. Since the FFC-CM does not have a touch screen or GUI, all commands must be performed via the API.
+Computer communication to the FFC-CM Laser Driver Boards occurs through the [[ffc:cm:api_i2c|I2C interface]]. Implementation of this interface has been left to the user. However, a list of API commands can be found below, or by downloading the FFC Gen2 Laser Driver Command API from the [[ffc:cm:api-ld#Links|downloads]] section.