Product Manuals

* Quick-Start Guides

• FFC-CM Quick Start

* Electronics

• FFC-CM Manual

* Websites

• FFC-CM web page
• Github page for FFC-100 firmware revisions

* Downloads

• ffc_gen2_laser_driver_command_api_r03.docx

Listed below is the command set for the Application Programming Interface (API) for the FFC-CM Laser Driver boards. Since the FFC-CM does not have a touch screen or GUI, all commands must be performed via the API.

Computer communication to the FFC-CM Laser Driver Boards occurs through the I2C interface. Implementation of this interface has been left to the user. However, a list of API commands can be found below, or by downloading the FFC Gen2 Laser Driver Command API from the downloads section.