Product Manuals

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

=====FFC-CM Fiber Laser Driver API=====

====Links====
* **Quick-Start Guides**
    * [[ffc:cm:quickstart|FFC-CM Quick Start]]

*  **Electronics**
    * [[ffc:cm:manual|FFC-CM Manual]]


*  **Websites**
    * [[https://vescent.com/us/ffc-100-frequency-comb.html|FFC-CM web page]]
    * [[https://github.com/Vescent/FFC_Firmware_Upgrade-and-FPGA-Software-Firmware|Github page for FFC-100 firmware revisions]]

*  **Downloads**
    * {{ :ffc:cm:ffc_gen2_laser_driver_command_api_r03.docx |}}

=====Implementation Instructions=====

Listed below is the command set for the Application Programming Interface (API) for the FFC-CM Laser Driver boards. Since the FFC-CM does not have a touch screen or GUI, all commands must be performed via the API.

Computer communication to the FFC-CM Laser Driver Boards occurs through the [[ffc:cm:api_i2c|I2C interface]]. Implementation of this interface has been left to the user. However, a list of API commands can be found below, or by downloading the FFC Gen2 Laser Driver Command API from the [[ffc:cm:api-ld#Links|downloads]] section.