Differences

This shows you the differences between two versions of the page.

--- ffc:cm:api-ld [2021/12/08 22:22] – external edit 127.0.0.1
+++ ffc:cm:api-ld [2022/03/29 17:19] (current) – external edit 127.0.0.1
@@ Line 14: / Line 14: @@
 *  **Downloads**
-    * {{ :ffc:cm:ffc_gen2_laser_driver_command_api.docx |}}
+    * {{ :ffc:cm:ffc_gen2_laser_driver_command_api_r03.docx |}}
 =====Implementation Instructions=====
@@ Line 20: / Line 20: @@
 Listed below is the command set for the Application Programming Interface (API) for the FFC-CM Laser Driver boards. Since the FFC-CM does not have a touch screen or GUI, all commands must be performed via the API.
-Computer communication to the FFC-CM Laser Driver Boards occurs through the [[ffc:cm:api-i2c|I<sup>2</sup>C interface]]. Implementation of this interface has been left to the user. However, a list of API commands can be found below, or by downloading the FFC Gen2 Laser Driver Command API from the [[ffc:cm:api-ld#Links|downloads]] section.
+Computer communication to the FFC-CM Laser Driver Boards occurs through the [[ffc:cm:api_i2c|I2C interface]]. Implementation of this interface has been left to the user. However, a list of API commands can be found below, or by downloading the FFC Gen2 Laser Driver Command API from the [[ffc:cm:api-ld#Links|downloads]] section.