d2:spectroscopy_module_210
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
d2:spectroscopy_module_210 [2016/08/31 10:35] – [Theory of Operation] Michael Radunsky | d2:spectroscopy_module_210 [2017/10/12 00:51] – [Inputs, Outputs, and Controls] Michael Radunsky | ||
---|---|---|---|
Line 78: | Line 78: | ||
**Input Connector**** (****6-pin circular)** | **Input Connector**** (****6-pin circular)** | ||
+ | <WRAP center round important 60%> | ||
+ | </ | ||
- | Power and temperature control signals from the D2-series power bus or other power supply are made through a 6-pin circular connector ([[http:// | + | Power and temperature control signals from the D2-series power bus, the ICE-PB1, |
< | < | ||
Line 129: | Line 131: | ||
**Tilt Plate** | **Tilt Plate** | ||
- | A polarizing beamsplitter (PBS) is fixed to a ball joint formed by a truncated steel ball held by a conformal brass ring. Two cone screws clamp the ring against the ball and fix the position of the PBS. See Alignment Procedure below for instructions on how to align and fix the PBS.{{ : | + | A polarizing beamsplitter (PBS) is fixed to a ball joint formed by a truncated steel ball held by a conformal brass ring. Two cone screws clamp the ring against the ball and fix the position of the PBS. See Alignment Procedure below for instructions on how to align and fix the PBS.<WRAP center round box 420px> |
+ | |||
+ | < | ||
**λ/2 Waveplate** | **λ/2 Waveplate** | ||
Line 135: | Line 139: | ||
A waveplate attached to the front plate by magnets can be used to select the splitting fraction of the Tilt Plate PBS. | A waveplate attached to the front plate by magnets can be used to select the splitting fraction of the Tilt Plate PBS. | ||
- | {{ : | + | <WRAP center round box 420px> |
+ | |||
+ | < | ||
d2/spectroscopy_module_210.txt · Last modified: 2024/03/27 15:58 by Thomas Bersano