Differences

This shows you the differences between two versions of the page.

--- d2:power_supply [2022/08/25 21:27] – external edit 127.0.0.1
+++ d2:power_supply [2023/02/01 21:10] (current) – external edit 127.0.0.1
@@ Line 26: / Line 26: @@
 =====Description=====
-The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules.
+The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 50/60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules.
 =====Symbols=====
@@ Line 94: / Line 94: @@
+=====Intended Use=====
+The D2-005 is intended to supply low-noise DC electrical power to the following Vescent D2 products:
+    *D2-105 Laser Controller
+    *D2-125 Reconfigurable Laser Servo
+    *D2-135 Offset Phase Lock Servo
+    *D2-210 Spectroscopy Module
+    *D2-260 Beat Note Detector
 =====Inputs, Outputs, and Controls=====
@@ Line 118: / Line 124: @@
-Power is supplied to the D2-005 via a standard C13 to Type-B power cord. Connections to additional electronics modules are made through 9-pin D-sub connectors via any compatible serial cable. The D2 Electronics implement a "daisy chain" power configuration, in which each subsequent unit can be powered through the unit before it in the chain and does not need to be powered directly by the D2-005. There are two 9-pin D-sub connectors on the back of the D2-005. Either or both can be used to power external electronics, however, current is shared between the two connectors. The maximum power rating for the 5V line is 30W (6A), and for the ±15V line is 22.5W (1.5A). The pin outs are shown in the following figure:
+Power is supplied to the D2-005 via a standard C13 to Type-B power cord. Connections to additional electronics modules are made through 9-pin D-sub connectors via any compatible serial cable. The D2 Electronics implement a "daisy chain" power configuration, in which each subsequent unit can be powered through the unit before it in the chain and does not need to be powered directly by the D2-005. There are two 9-pin D-sub connectors on the back of the D2-005. Either or both can be used to power external electronics, however, maximum rated current is shared between the two connectors. The maximum power rating for the 5V line is 30W (6A), and for the ±15V line is 22.5W (1.5A). The pin outs are shown in the following figure:
 {{ :d2:d-sub_power_pinout.jpg?nolink&150 |}}