d2:power_supply
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
d2:power_supply [2014/07/31 01:37] – external edit 127.0.0.1 | d2:power_supply [2020/12/11 22:08] – [Specifications] Michael Radunsky | ||
---|---|---|---|
Line 12: | Line 12: | ||
Please read [[: | Please read [[: | ||
+ | |||
+ | Link to [[https:// | ||
Line 17: | Line 19: | ||
The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules. | The Power Supply is a quiet, linear power supply providing +/-15V and 5V. It is in a separate box to isolate 60 Hz and EM interference. One power supply can power two complete laser systems, or four electronics modules. | ||
+ | |||
+ | =====Purchase Includes===== | ||
+ | * D2-005 Power Supply | ||
+ | * VPN00464 Power Cord | ||
+ | |||
+ | |||
+ | |||
===== Absolute Maximum Ratings ===== | ===== Absolute Maximum Ratings ===== | ||
Line 33: | Line 42: | ||
^ ^^ | ^ ^^ | ||
^Current Limit | | | | ^Current Limit | | | | ||
- | |< | + | |+15V| |
- | |< | + | |-15V| |
- | |< | + | |+5V| 6 | A | |
^Output Regulation | 0.05 | % | | ^Output Regulation | 0.05 | % | | ||
Line 55: | Line 64: | ||
**Power I/O (9-pin D-sub)** | **Power I/O (9-pin D-sub)** | ||
+ | <WRAP center round important 60%> | ||
+ | Always turn off the D2-005, make connections to the device, and then re-energize the D2-005. | ||
+ | </ | ||
+ | |||
+ | <WRAP center round important 60%> | ||
+ | If you are considering using an Uninterruptible Power Supply (UPS) to guarantee operation of your Vescent products through a brown out or black out, great care should be taken in choosing the model. | ||
+ | </ | ||
The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit. The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels. | The power to each electronics module is through a 9-pin D-sub connector through a power bridge unit. The unit can also be powered through any serial cable with 9-pin D-sub connectors, which is convenient when the unit must be taken out of line for access to the side panels. |
d2/power_supply.txt · Last modified: 2023/02/01 21:10 by 127.0.0.1