Differences

This shows you the differences between two versions of the page.

--- d2:heterodyne_module [2013/08/13 20:50] – [Specifications] Ben Luey
+++ d2:heterodyne_module [2015/11/19 16:58] – [Specifications] Michael Radunsky
@@ Line 1: / Line 1: @@
-<WRAP right round box 260px>
+<WRAP right round box 300px>
-[{{  :d2:d2-105:lasercontroller.jpg?nolink&240 |D2-150 Heterodyne Module}}]
+[{{  :d2:d2-150:heterodyne_module_small.jpg?nolink&280 |D2-150 Heterodyne Module}}]
 </WRAP>
@@ Line 37: / Line 37: @@
 ^Proportion of light picked-off|  1-2.5  |  %  |
 ^Wavelength Range|  630-1000  |  nm  |
+^Output Fiber Connector|  FC  |   |
 </WRAP>
@@ Line 65: / Line 66: @@
 The procedure outlined above should work to align the module, but if difficulties are encountered another alignment procedure is possible with a fiber coupled laser such as the laser pens that are used to check fiber continuity and align light into fibers.  In this procedure, light should travel the reverse direction through the fiber so that the light is output into the module.  The beams should then be adjusted such that this reverse-coupled light overlaps well with the two laser beams entering the module.