d2:dbr_laser
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
d2:dbr_laser [2022/08/17 21:54] – external edit 127.0.0.1 | d2:dbr_laser [2022/09/08 21:50] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 12: | Line 12: | ||
Please read [[: | Please read [[: | ||
- | < | + | {{d2: |
Line 130: | Line 130: | ||
==== Safety Information ==== | ==== Safety Information ==== | ||
+ | <WRAP center round important 60%> | ||
+ | The D2-100 is only specified for use with the Vescent D2-105 laser controller, and with cables provided by Vescent. | ||
+ | </ | ||
+ | |||
The D2-100 is a Class 3B CW laser product under the guidelines provided in IEC 60825-01: | The D2-100 is a Class 3B CW laser product under the guidelines provided in IEC 60825-01: | ||
Line 136: | Line 140: | ||
The Maximum Permissable Exposire (MPE) for the D2-100 is 14.45 W*m< | The Maximum Permissable Exposire (MPE) for the D2-100 is 14.45 W*m< | ||
- | There are three safety stickers present on the D2-100. The first, located on the side of the isolator module, is the explanatory sticker, which states the classification of the laser, and several safety instructions. It reads: " | + | There are four safety stickers present on the D2-100. The first, located on the side of the isolator module, is the explanatory sticker, which states the classification of the laser, and several safety instructions. It reads: " |
< | < | ||
+ | |||
+ | On the side of the isolator module opposite the explanatory sticker is a sticker which lists the maximum possible output of the laser in mW, the wavelength of the laser, and the name of the IEC certification standard to which the laser adheres. | ||
+ | |||
+ | < | ||
On the top of the D2-100, near the laser aperture, is a "Laser Aperture" | On the top of the D2-100, near the laser aperture, is a "Laser Aperture" | ||
Line 148: | Line 156: | ||
< | < | ||
- | There is only one laser aperture on the D2-100, located on the front as shown in (< | + | There is only one laser aperture on the D2-100, located on the front with the isolator |
+ | |||
+ | Safe operation of the D2-100 necessitates that a compliant laser driver be used to supply a current to the diode. It is important to always correctly set the current limit on any laser driver before energizing the laser system. The D2-100 is a Cathode-Ground laser, and requires a DC current between 0mA and 500mA((Specific current for each laser supplied with test documentation)) to be safely turned on. The connector used to supply current to the D2-100 is a female SMA, which requires a male SMA cable for compatibility. |
d2/dbr_laser.txt · Last modified: 2024/03/29 22:18 by Thomas Bersano