d2:dbr_laser
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
d2:dbr_laser [2019/09/24 21:21] – [Inputs, Outputs, and Controls] Michael Radunsky | d2:dbr_laser [2019/09/24 21:23] – [Inputs, Outputs, and Controls] Michael Radunsky | ||
---|---|---|---|
Line 76: | Line 76: | ||
- | =====Inputs, Outputs, and Controls===== | + | =====Laser Control Signals===== |
<WRAP center round box 60%> | <WRAP center round box 60%> | ||
| {{ : | | {{ : | ||
Line 124: | Line 124: | ||
- | =====Aligning the DBR Laser Module===== | ||
- | The module should not need adjustments, | ||
- | |||
- | - Loosen the three locking screws on the back of the DBR module ½ turn past the crack point. | ||
- | - With a 0.050" Allen driver, adjust the vertical adjustment setscrew on the top of the DBR housing to level the beam. | ||
- | - Adjust the horizontal adjustment 4-40 set screw on the left side of the DBR housing (See <imgref DBR_lock_screws> | ||
- | - Alternatively, | ||
- | - Gently retighten the three locking screws. | ||
d2/dbr_laser.txt · Last modified: 2024/03/29 22:18 by Thomas Bersano