slice:z-n
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:z-n [2019/07/29 21:10] – [Instructions] Michael Radunsky | slice:z-n [2020/08/21 15:46] – [Instructions] Michael Radunsky | ||
---|---|---|---|
Line 20: | Line 20: | ||
- Set Proportional Gain (K< | - Set Proportional Gain (K< | ||
- Turn off Integral and Differential portions of the loop (T< | - Turn off Integral and Differential portions of the loop (T< | ||
- | - While monitoring the error in temperature on rolling graph on the SLICE-QT display or an [[slice: | + | - While monitoring the error in temperature on rolling graph on the SLICE-QTC display or an [[slice: |
- Use the {{slice: | - Use the {{slice: | ||
- Use the {{slice: | - Use the {{slice: | ||
- Note: the pause icon only pauses the graph, not the servo control | - Note: the pause icon only pauses the graph, not the servo control | ||
- | - Note K< | + | - Note K< |
- Use the Cursors enabled by touching the {{slice: | - Use the Cursors enabled by touching the {{slice: | ||
- You can use the two rotary knobs or touch & drag the cursors on the touch screen | - You can use the two rotary knobs or touch & drag the cursors on the touch screen |
slice/z-n.txt · Last modified: 2022/07/18 17:18 by 127.0.0.1