slice:z-n
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:z-n [2019/04/02 16:06] – [Instructions] Michael Radunsky | slice:z-n [2019/04/03 00:11] – [Instructions] Michael Radunsky | ||
---|---|---|---|
Line 18: | Line 18: | ||
- Set Proportional Gain (K< | - Set Proportional Gain (K< | ||
- Turn off Integral and Differential portions of the loop (T< | - Turn off Integral and Differential portions of the loop (T< | ||
- | - While monitoring the error in temperature on rolling graph on the SLICE-QT display((It is also possible to [[slice: | + | - While monitoring the error in temperature on rolling graph on the SLICE-QT display |
- Use the {{slice: | - Use the {{slice: | ||
- Use the {{slice: | - Use the {{slice: | ||
+ | - Note: the pause icon only pauses the graph, not the servo control | ||
- Note K< | - Note K< | ||
- Use the Cursors enabled by touching the {{slice: | - Use the Cursors enabled by touching the {{slice: | ||
+ | - You can use the two rotary knobs or touch & drag the cursors on the touch screen | ||
- Use the following table to set the values of K< | - Use the following table to set the values of K< | ||
<WRAP center round box 60%>< | <WRAP center round box 60%>< | ||
- | | **Type of Control Loop** | + | | **Type of Control Loop** |
- | | **PI** | + | | **PI** |
- | | **PID** | + | | **PID** |
</ | </ | ||
slice/z-n.txt · Last modified: 2022/07/18 17:18 by 127.0.0.1