slice:qt
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:qt [2021/08/26 14:26] – external edit 127.0.0.1 | slice:qt [2022/04/01 18:03] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 52: | Line 52: | ||
| {{ : | | {{ : | ||
|:::| Successful implementation of the SLICE-QTC depends critically on the design of the whole system: controller, transducer, plant, and sensor. | | |:::| Successful implementation of the SLICE-QTC depends critically on the design of the whole system: controller, transducer, plant, and sensor. | | ||
+ | |:::| The back panel TEC hookups should **never** be shorted to ground while the SLICE-QTC is supplying current. Doing so is likely to cause severe damage. | | ||
==== Tips for Successful Temperature Regulation ==== | ==== Tips for Successful Temperature Regulation ==== | ||
Line 397: | Line 398: | ||
===== Serial API ===== | ===== Serial API ===== | ||
It is possible to control the SLICE-QTC through serial commands. | It is possible to control the SLICE-QTC through serial commands. | ||
+ | |||
+ | <WRAP round important 100%> | ||
+ | Upgrading the SLICE-QTC firmware is not always necessary to use the Serial API. Check your installed firmware version in the settings menu against the most recent firmware version given [[https:// | ||
+ | </ | ||
More information coming soon. Please contact [[[email protected]|sales [at] vescent [dot] com]] for information. | More information coming soon. Please contact [[[email protected]|sales [at] vescent [dot] com]] for information. |
slice/qt.txt · Last modified: 2023/08/11 15:53 by 127.0.0.1