slice:qt
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:qt [2020/09/01 18:52] – [SLICE-QTC Four-Channel Temperature Controller] Michael Radunsky | slice:qt [2021/12/15 21:06] – external edit 127.0.0.1 | ||
---|---|---|---|
Line 8: | Line 8: | ||
Please read [[: | Please read [[: | ||
- | Temporary edit | ||
- | |||
==== Links ==== | ==== Links ==== | ||
Line 74: | Line 72: | ||
| Channels | | Channels | ||
| Loop Filter | | Loop Filter | ||
- | | Control Range((Lower precision may be realized above 50°C. Consider using a thermistor with 10 kΩ at higher temperature than nominal.)) | + | | Control Range | -10 to +120°C |
| Compatible Transducer | | Compatible Transducer | ||
| Compatible Sensor | | Compatible Sensor | ||
Line 256: | Line 254: | ||
To set the properties of the transducer (TEC or heater) and thermistor for an individual channel from the Home screen, touch CH X > Settings > Plant. | To set the properties of the transducer (TEC or heater) and thermistor for an individual channel from the Home screen, touch CH X > Settings > Plant. | ||
- | From this screen, it is also possible to set the polarity of the TEC. Touch Polarity Positive/ | + | From this screen, it is also possible to set the polarity of the TEC. Touch Polarity Positive/ |
The thermistor data has been configured at the factory for a typical NTC thermistor that is 10 kΩ at 25°C. | The thermistor data has been configured at the factory for a typical NTC thermistor that is 10 kΩ at 25°C. | ||
Line 399: | Line 397: | ||
===== Serial API ===== | ===== Serial API ===== | ||
It is possible to control the SLICE-QTC through serial commands. | It is possible to control the SLICE-QTC through serial commands. | ||
+ | |||
+ | <WRAP round important 100%> | ||
+ | Upgrading the SLICE-QTC firmware is not always necessary to use the Serial API. Check your installed firmware version in the settings menu against the most recent firmware version given [[https:// | ||
+ | </ | ||
More information coming soon. Please contact [[[email protected]|sales [at] vescent [dot] com]] for information. | More information coming soon. Please contact [[[email protected]|sales [at] vescent [dot] com]] for information. |
slice/qt.txt · Last modified: 2023/08/11 15:53 by 127.0.0.1