Differences

This shows you the differences between two versions of the page.

--- slice:qt [2019/08/22 22:29] – [Entering Values] Michael Radunsky
+++ slice:qt [2019/08/26 23:39] – [Using the Host GUI] Michael Radunsky
@@ Line 177: / Line 177: @@
 To set the temperature set point from the home screen, touch the Setpoint window for the desired channel (circled in red for CH 1 in <imgref home_Tset1>).  A long touch will cause a keypad to appear.  Enter desired value and touch the accept button.
-A short touch will highlight the Setpoint window in yellow (<imgref home_Tset2>).  Use rotary knobs to select digit to edit (right knob) and value for digit (left knob).\\
+A short touch will highlight the Setpoint window in yellow (<imgref home_Tset2>).  Use rotary knobs to select digit to edit (left knob) and value for digit (right knob).\\
 <imgcaption home_Tset1|Select Temperature setpoint for CH 1>{{ :slice:slice-qt_set_t_home_1.png?400x254 |}}</imgcaption>
@@ Line 369: / Line 369: @@
 It is possible to control the SLICE-QTC from a Windows<sup>®</sup>-based PC using a GUI.  In order to use the GUI, you must first download the latest version, connect the PC to the SLICE-QTC, and assign a COM port to the SLICE-QTC.  The following describes the steps involved.
-  - Download and store the latest GUI executable from the FTP site (Request copy of executable GUI from [[[email protected]|sales [at] vescent [dot] com]]).
+  - Download and store the latest GUI executable from [[ https://github.com/Vescent| the Vescent FTP site]] (or request copy of executable GUI from [[[email protected]|sales [at] vescent [dot] com]]).
   - Connect the SLICE-QTC to the PC using a USB type B cable.
   - Turn on the SLICE-QTC.