slice:dcc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:dcc [2020/04/29 22:25] – [Specifications] Michael Radunsky | slice:dcc [2020/04/29 22:51] – [Setting the Operation Mode] Michael Radunsky | ||
---|---|---|---|
Line 203: | Line 203: | ||
The Home screen displays the status of both channels (<imgref home_scr_dcc> | The Home screen displays the status of both channels (<imgref home_scr_dcc> | ||
==== Connecting to the Laser Diode ==== | ==== Connecting to the Laser Diode ==== | ||
- | The SLICE-DCC requires that the cathode of the laser diode is at ground. | + | The SLICE-DCC requires that the cathode of the laser diode is at ground |
+ | |||
+ | < | ||
==== Setting the Operation Mode ==== | ==== Setting the Operation Mode ==== | ||
Line 216: | Line 218: | ||
Touching the Window labeled Control Mode will allow you to toggle the channel back & forth between Constant Current and Constant Power modes as seen in <imgref cc_cp>. | Touching the Window labeled Control Mode will allow you to toggle the channel back & forth between Constant Current and Constant Power modes as seen in <imgref cc_cp>. | ||
- | < | + | < |
==== Setting the Current Limit ==== | ==== Setting the Current Limit ==== | ||
The user can set a maximum deliverable current so as not to exceed the rated maximum for their device. | The user can set a maximum deliverable current so as not to exceed the rated maximum for their device. |
slice/dcc.txt · Last modified: 2024/03/27 21:07 by Thomas Bersano