slice:dcc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
slice:dcc [2020/04/29 22:04] – [Rear Panel] Michael Radunsky | slice:dcc [2020/04/29 22:51] – [Connecting to the Laser Diode] Michael Radunsky | ||
---|---|---|---|
Line 99: | Line 99: | ||
| \\ \\ Maximum Current | | \\ \\ Maximum Current | ||
| \\ \\ Current Noise((Constant Current Mode)) ((rms 100 Hz to 1 MHz)) | 1.5\\ 4\\ 10\\ 15 | | | \\ \\ Current Noise((Constant Current Mode)) ((rms 100 Hz to 1 MHz)) | 1.5\\ 4\\ 10\\ 15 | | ||
- | | Input Impedance \\ Rear \\ Front | \\ >20 kΩ\\ 50 Ω or 1 MΩ | | + | | Current Modulation |
| Modulation Bandwidth((-3 dB point)), ((front & rear modulation input ports))| | | Modulation Bandwidth((-3 dB point)), ((front & rear modulation input ports))| | ||
|Modulation Depth \\ SLICE-DCC-200\\ SLICE-DCC-500\\ SLICE-DCC-1000\\ SLICE-DCC-2000 | \\ ±10 mA\\ ±25 mA\\ ±50 mA\\ ±50 mA | | |Modulation Depth \\ SLICE-DCC-200\\ SLICE-DCC-500\\ SLICE-DCC-1000\\ SLICE-DCC-2000 | \\ ±10 mA\\ ±25 mA\\ ±50 mA\\ ±50 mA | | ||
Line 107: | Line 107: | ||
| Drift | <25 µA/ | | Drift | <25 µA/ | ||
| Power Stability((constant power mode)) | | Power Stability((constant power mode)) | ||
+ | | Monitor Photodiode Input Current Range | ±5 mA | | ||
| Maximum Compliance Voltage | | Maximum Compliance Voltage | ||
| Triggering | | Triggering | ||
Line 201: | Line 202: | ||
===== SLICE-DCC Operation ===== | ===== SLICE-DCC Operation ===== | ||
The Home screen displays the status of both channels (<imgref home_scr_dcc> | The Home screen displays the status of both channels (<imgref home_scr_dcc> | ||
+ | ==== Connecting to the Laser Diode ==== | ||
+ | The SLICE-DCC requires that the cathode of the laser diode is at ground (<imgref cath_gnd> | ||
+ | |||
+ | < | ||
+ | |||
==== Setting the Operation Mode ==== | ==== Setting the Operation Mode ==== | ||
The SLICE-DCC has two operation modes: Constant Current and Constant Power. | The SLICE-DCC has two operation modes: Constant Current and Constant Power. |
slice/dcc.txt · Last modified: 2024/03/27 21:07 by Thomas Bersano