ice:commands:peaklock
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
ice:commands:peaklock [2016/07/22 17:58] – add pole values Ben Luey | ice:commands:peaklock [2017/05/04 17:35] – Michael Radunsky | ||
---|---|---|---|
Line 69: | Line 69: | ||
< | < | ||
- | Sets the Integrator Op-Amp’s Offset Voltage adjustment value. This should be factory set, but it controls the DC Error Input voltage that the servo locks to (should be 0V) OFFSET is an integer from 0-255. Returns the output of the command **OpOffst? | + | Sets the Integrator Op-Amp’s Offset Voltage adjustment value. This should be factory set and typically should be set to 128, but it controls the DC Error Input voltage that the servo locks to (should be 0V) OFFSET is an integer from 0-255. Returns the output of the command **OpOffst? |
< | < | ||
ice/commands/peaklock.txt · Last modified: 2023/11/30 21:32 by 127.0.0.1