Differences

This shows you the differences between two versions of the page.

--- d2:dbr_laser [2022/08/17 22:04] – external edit 127.0.0.1
+++ d2:dbr_laser [2022/09/01 18:31] – external edit 127.0.0.1
@@ Line 130: / Line 130: @@
 ==== Safety Information ====
+<WRAP center round important 60%>
+The D2-100 is only specified for use with the Vescent D2-105 laser controller, and with cables provided by Vescent.
+</WRAP>
 The D2-100 is a Class 3B CW laser product under the guidelines provided in IEC 60825-01:2014. It has no serviceable parts, and should not be disassembled in the field under any circumstance. Viewing of the beam, either directly, with viewing optics, or from a specular reflection can cause damage to the eye, and should be avoided.
@@ Line 150: / Line 154: @@
 There is only one laser aperture on the D2-100, located on the front with the isolator as shown in (<imgref DBR_laser>).
-Safe operation of the D2-100 necessitates that a compliant laser driver be used to supply a current to the diode. It is important to always correctly set the current limit on any laser driver before energizing the laser system. The D2-100 is a Cathode-Ground laser, and requires a DC current between 0mA and 500mA((specific current for each laser supplied with test documentation)) to be safely turned on. The connector used to supply current to the D2-100 is a female SMA, which requires a male SMA cable for compatibility.
+Safe operation of the D2-100 necessitates that a compliant laser driver be used to supply a current to the diode. It is important to always correctly set the current limit on any laser driver before energizing the laser system. The D2-100 is a Cathode-Ground laser, and requires a DC current between 0mA and 500mA((Specific current for each laser supplied with test documentation)) to be safely turned on. The connector used to supply current to the D2-100 is a female SMA, which requires a male SMA cable for compatibility.