d2:dbr_laser
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
d2:dbr_laser [2016/11/28 23:31] – [Specifications] Michael Radunsky | d2:dbr_laser [2017/10/12 00:39] – [Inputs, Outputs, and Controls] Michael Radunsky | ||
---|---|---|---|
Line 123: | Line 123: | ||
**Laser Current (SMA)** | **Laser Current (SMA)** | ||
+ | <WRAP center round important 60%> | ||
+ | Never connect or disconnect the D2-100 Laser to a laser controller that is energized. | ||
+ | |||
+ | Always make sure to make a snug connection between the D2-100 and the current-carrying SMA cable, and between the cable and the laser controller. | ||
+ | </ | ||
Current is provided to the DBR chip through an SMA connector. | Current is provided to the DBR chip through an SMA connector. |
d2/dbr_laser.txt · Last modified: 2024/03/29 22:18 by Thomas Bersano