User Tools

Site Tools


warnings_cautions

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
warnings_cautions [2013/07/31 16:04] – Initial Document Load Ben Lueywarnings_cautions [2022/04/01 19:09] (current) – external edit 127.0.0.1
Line 33: Line 33:
 modules may be cleaned with a mild soap and water solution. modules may be cleaned with a mild soap and water solution.
 Do not clean optics modules. </WRAP> Do not clean optics modules. </WRAP>
 +
 +<WRAP left round box 60%>
 +| {{ :warning-sign.png?nolink&100 | }}| Never connect or disconnect the D2-105 Laser Controller to/from a laser with the D2-105 energized.  Always power down the D2-105 completely before making connections to the laser.|
 +</WRAP>
 +
 +<WRAP left round box 60%>
 +| {{ :warning-sign.png?100&nolink }}  | Any input/output connections to the SLICE instrument must be derived from a Safety Extra Low Voltage (SELV) source.                                                           |
 +| :::                                 | If this instrument is used in a manner not specified by the manufacturer in this manual or other relevant literature, protection provided by the instrument may be impaired.  |
 +</WRAP>
 +
 +
 +<WRAP left round box 60%>
 +| {{ :warning-sign.png?100&nolink }}  | **Never** connect either of the TEC leads on a plant or the SLICE-QTC to ground. This configuration is very likely to cause severe damage to the SLICE-QTC.  |
 +</WRAP>
  
  
  
warnings_cautions.1375286647.txt.gz · Last modified: 2021/08/26 14:26 (external edit)