User Tools

Site Tools


slice:z-n

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
slice:z-n [2019/04/03 00:11] – [Instructions] Michael Radunskyslice:z-n [2019/07/29 21:10] – [Instructions] Michael Radunsky
Line 7: Line 7:
 Click here for the [[slice:qt:API|SLICE-QT API]].\\ Click here for the [[slice:qt:API|SLICE-QT API]].\\
 Click here for the [[https://www.vescent.com/products/electronics/slice/slice-qt-four-channel-temperature-controller/|SLICE-QT web page]].\\ Click here for the [[https://www.vescent.com/products/electronics/slice/slice-qt-four-channel-temperature-controller/|SLICE-QT web page]].\\
 +Click here for the [[https://github.com/Vescent|Github page for SLICE-QTC GUI]]\\
 +Click here for the [[https://github.com/Vescent/SLICE-QT-Firmware-Upgrade|Github page for SLICE-QTC firmware revisions]]\\
  
 ==== Instructions ==== ==== Instructions ====
Line 22: Line 24:
   - Use the {{slice:graph_pause.gif}} icon to pause the graph   - Use the {{slice:graph_pause.gif}} icon to pause the graph
     - Note: the pause icon only pauses the graph, not the servo control     - Note: the pause icon only pauses the graph, not the servo control
-  - Note K<sub>P</sub> where oscillation beginsK<sub>P, cr</sub>+  - Note K<sub>P</sub> where oscillation begins; this is K<sub>P, cr</sub>
   - Use the Cursors enabled by touching the {{slice:cursors.gif}} icon to measure the period of oscillation, T<sub>cr</sub>   - Use the Cursors enabled by touching the {{slice:cursors.gif}} icon to measure the period of oscillation, T<sub>cr</sub>
         - You can use the two rotary knobs or touch & drag the cursors on the touch screen         - You can use the two rotary knobs or touch & drag the cursors on the touch screen
slice/z-n.txt · Last modified: 2022/07/18 17:18 by 127.0.0.1