Differences

This shows you the differences between two versions of the page.

--- slice:qt:api [2020/05/22 23:38] – [SLICE-QTC Specific Notes] Michael Radunsky
+++ slice:qt:api [2021/02/17 01:15] – [Reset to Factory Default Settings] Michael Radunsky
@@ Line 57: / Line 57: @@
 </WRAP>
 ----
+====Save Settings====
 <function=ICEfunc|0=SAVE&1=:None;&2=SUCCESS&-1>
 Saves "Personality Board" settings into EEPROM.  Unsaved changes will be lost if board is powered off without issuing a SAVE command. The SAVE command saves the entire configuration into non-volatile memory. A single SAVE command can be issued after any number of configuration changes. When changes are made to the SLICE configuration through the touch screen, the new values are automatically saved and it is not necessary to issue a SAVE command.\\ \\
@@ Line 267: / Line 268: @@
 ^  Input Function       ^  CHANNEL  ^  FUNCTION  ^  VALUE1        ^  VALUE2                ^  VALUE3               ^
 |                       |  [Int]    |  [Int]     |  [Float]       |  [Float]               |  [Int]               |
-| Slow Servo            |  1 - 4    |  0         | Integral Gain  | Set point voltage [V]  | Polarity [0/1 = +/-] |
+| Off                   |  1 - 4    |  0         | N/A            | N/A                    | N/A                  |
-| External Temperature  |  1 - 4    |  1         | Gain [˚C/V]    | Offset [V]             | N/A                  |
+| External Setpoint\\ Absolute  |  1 - 4  |  1   | Gain [˚C/V]    | Offset [V]             | N/A                  |
-| External Error        |  1 - 4    |  2         | Gain [˚C/V]    | Offset [V]             | N/A                  |
+| External Setpoint\\ Relative  |  1 - 4  |  2   | Gain [˚C/V]    | Offset [V]             | N/A                  |
-| External Setpoint     |  1 - 4    |  3         | Gain [˚C/V]    | Offset [V]             | N/A                  |
+| External Temperature\\ Input  |  1 - 4  |  3   | Gain [˚C/V]    | Offset [V              | N/A                  |
-| Feedforward           |  1 - 4    |  4         | Gain [A/V]     | Offset [V]             | N/A                  |
+| External Error Input  |  1 - 4    |  4         | Gain [A/V]     | Offset [V]             | N/A                  |
+| Feedforward           |  1 - 4    |  5         | Gain [A/V]     | Offset [V]             | N/A                  |
+| Slow Servo  Input     |  1 - 4    |  6         | Integral Gain  | Set point voltage [V]  | Polarity [0/1 = +/-] |
 ----