Differences

This shows you the differences between two versions of the page.

--- slice:qt:api [2019/10/30 00:19] – [Thermistor Settings] Michael Radunsky
+++ slice:qt:api [2019/10/31 20:57] – [Thermistor Settings] Michael Radunsky
@@ Line 110: / Line 110: @@
 ----
 <function=ICEfunc|0=Beta&1=I:CHANNEL:2;F:VALUE:3450&2=3450.0&-1>
-For the B-parameter thermistor model: Sets the Beta coefficient in Kelvin [K] to VALUE for CHANNEL. Returns **Beta?**.
+For the B-parameter thermistor model: Sets the Beta coefficient in Kelvin [K] to VALUE for CHANNEL. Returns **Beta?**. Execute a TEMPLUT command after setting Beta through the API (QC firmware versions 1.14 & lower).
 ----
 <function=ICEfunc|0=RefTemp?&1=I:CHANNEL:1&2=25.0&-1>
@@ Line 116: / Line 116: @@
 ----
 <function=ICEfunc|0=RefTemp&1=I:CHANNEL:2;F:VALUE:25.0&2=25.0&-1>
-For the B-parameter thermistor model: Sets the Reference Temperature in degrees Celsius [˚C] to VALUE for CHANNEL. Returns **RefTemp?**.
+For the B-parameter thermistor model: Sets the Reference Temperature in degrees Celsius [˚C] to VALUE for CHANNEL. Returns **RefTemp?**. Execute a TEMPLUT command after setting the Reference Temperature through the API (QC firmware versions 1.14 & lower).
 ----
 <function=ICEfunc|0=RefRes?&1=I:CHANNEL:1&2=10000.0&-1>
@@ Line 143: / Line 143: @@
 ----
 <function=ICEfunc|0=TEMPLUT&1=I:CHANNEL:1&2=&-1>
-Forces recalculation of T = ƒ(A,B,C) lookup table.  There is no output from this command.  Execute this command after setting any of the Steinhart-Hart coefficients via the API (QC firmware versions 1.14 & lower).
+Forces recalculation of T = ƒ(A,B,C) lookup table.  There is no output from this command.  Execute this command after setting any of the Steinhart-Hart coefficients, Beta Parameter, or Reference Temperature via the API (QC firmware versions 1.14 & lower).
 ----
 ===== Loop Filter Settings =====