Differences

This shows you the differences between two versions of the page.

--- slice:qt:api [2019/10/29 21:41] – [Loop Filter Settings] Michael Radunsky
+++ slice:qt:api [2019/10/30 00:19] – [Thermistor Settings] Michael Radunsky
@@ Line 128: / Line 128: @@
 ----
 <function=ICEfunc|0=TCoefA&1=I:CHANNEL:1;F:VALUE:2.108508173&2=2.108508173&-1>
-For the Steinhart-Hart thermistor model: Sets the A coefficient to VALUE for CHANNEL. Returns **TCoefA?**.
+For the Steinhart-Hart thermistor model: Sets the A coefficient to VALUE for CHANNEL. Returns **TCoefA?**. Execute a TEMPLUT command after setting any of the Steinhart-Hart coefficients through the API (QC firmware versions 1.14 & lower).
 ----
 <function=ICEfunc|0=TCoefB?&1=I:CHANNEL:1&2=0.797204727&-1>
@@ Line 134: / Line 134: @@
 ----
 <function=ICEfunc|0=TCoefB&1=I:CHANNEL:1;F:VALUE:0.797204727&2=0.797204727&-1>
-For the Steinhart-Hart thermistor model: Sets the B coefficient to VALUE for CHANNEL. Returns **TCoefB?**.
+For the Steinhart-Hart thermistor model: Sets the B coefficient to VALUE for CHANNEL. Returns **TCoefB?**. Execute a TEMPLUT command after setting any of the Steinhart-Hart coefficients through the API (QC firmware versions 1.14 & lower).
 ----
 <function=ICEfunc|0=TCoefC?&1=I:CHANNEL:1&2=6.535076315&-1>
@@ Line 140: / Line 140: @@
 ----
 <function=ICEfunc|0=TCoefC&1=I:CHANNEL:1;F:VALUE:6.535076315&2=6.535076315&-1>
-For the Steinhart-Hart thermistor model: Sets the C coefficient to VALUE for CHANNEL. Returns **TCoefC?**.
+For the Steinhart-Hart thermistor model: Sets the C coefficient to VALUE for CHANNEL. Returns **TCoefC?**. Execute a TEMPLUT command after setting any of the Steinhart-Hart coefficients through the API (QC firmware versions 1.14 & lower).
+----
+<function=ICEfunc|0=TEMPLUT&1=I:CHANNEL:1&2=&-1>
+Forces recalculation of T = ƒ(A,B,C) lookup table.  There is no output from this command.  Execute this command after setting any of the Steinhart-Hart coefficients via the API (QC firmware versions 1.14 & lower).
 ----
 ===== Loop Filter Settings =====
@@ Line 207: / Line 210: @@
 <function=ICEfunc|0=SlewEn&1=I:CHANNEL:3;I:STATE:1&2=1&-1>
 Sets the On/Off STATE of the slew rate limiter for CHANNEL. Returns **SlewEn?**.
+----
+===== System Functions =====
 ----
 <function=ICEfunc|0=Save&1=A:None:&2=Success&-1>