User Tools

Site Tools


slice:qt:api

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
slice:qt:api [2019/02/27 11:01]
Michael Radunsky [I/O Channel Settings]
slice:qt:api [2019/06/05 08:53]
Michael Radunsky
Line 1: Line 1:
-======SLICE-QT API======+======SLICE-QTC API======
  
 ====Links==== ====Links====
 * **Quick-Start Guides** * **Quick-Start Guides**
-    * [[slice:​quick_start_qt|SLICE-QT Quick Start]]+    * [[slice:​quick_start_qt|SLICE-QTC Quick Start]]
  
 *  **Electronics** *  **Electronics**
-    * [[slice:​qt|SLICE-QT Manual]] +    * [[slice:​qt|SLICE-QTC Manual]] 
-    * [[slice:​qt:​firmware|SLICE-QT firmware upgrade instructions]]+    * [[slice:​qt:​firmware|SLICE-QTC firmware upgrade instructions]]
  
 *  **Websites** *  **Websites**
-    * [[https://​www.vescent.com/​products/​electronics/​slice/​slice-qt-four-channel-temperature-controller/​|SLICE-QT web page]]+    * [[https://​www.vescent.com/​products/​electronics/​slice/​slice-qt-four-channel-temperature-controller/​|SLICE-QTC web page]] 
 +    * [[https://​github.com/​Vescent|Github page for SLICE-QTC GUI]] 
 +    * [[https://​github.com/​Vescent/​SLICE-QT-Firmware-Upgrade|Github page for SLICE-QTC firmware revisions]]
 =====Implementation Instructions===== =====Implementation Instructions=====
  
Line 33: Line 35:
   - [Int] refers to an integer argument that has no decimal point.   - [Int] refers to an integer argument that has no decimal point.
   - [Float] refers to a floating point argument that has a decimal point in its value.   - [Float] refers to a floating point argument that has a decimal point in its value.
-===== SLICE-QT Specific Notes =====+===== SLICE-QTC Specific Notes =====
   - Valid values for the CHANNEL argument are {1, 2, 3, 4}.   - Valid values for the CHANNEL argument are {1, 2, 3, 4}.
   - All enable commands use an integer argument to convey the state: 0 = Off, 1 = On.   - All enable commands use an integer argument to convey the state: 0 = Off, 1 = On.
slice/qt/api.txt · Last modified: 2019/10/31 14:01 by Michael Radunsky