User Tools

Site Tools


slice:qt

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
slice:qt [2019/09/18 13:18] – [Specifications] Michael Radunskyslice:qt [2019/12/04 20:04] – [Proper Usage] Michael Radunsky
Line 51: Line 51:
 ===== Proper Usage ===== ===== Proper Usage =====
 | {{ :warning-sign.png?100&nolink }}  | If this instrument is used in a manner not specified by the manufacturer in this manual or other relevant literature, protection provided by the instrument may be impaired. | | {{ :warning-sign.png?100&nolink }}  | If this instrument is used in a manner not specified by the manufacturer in this manual or other relevant literature, protection provided by the instrument may be impaired. |
 +|:::| Successful implementation of the SLICE-QTC depends critically on the design of the whole system: controller, transducer, plant, and sensor. |
 +
 +==== Tips for Successful Temperature Regulation ==== 
 +  -  The transducer, plant, and sensor must all be in good thermal contact. Use thermal paste or epoxy to avoid air gaps between a TEC or heater and the body of the plant as well as to secure the thermistor to the plant.
 +  - Know the electrical limits of of your transducer and set the limits of the SLICE-QTC accordingly.  Each channel can provide up to  6 A or 20 W of power with a maximum compliance voltage up to ~18 V.  Choose transducers that work within these limits.  Using the current, power, and/or voltage ratings of your transducer to calculate loads on individual channels and set limits appropriately in the CH X > Settings > Load Limits window.
 +  - Maintain proper shielding of the control cable, but avoid ground loops between the SLICE-QTC and the plant.  In most cases this means extending the foil shield in the cable to as close as possible to the plant without electrically connecting the SLICE-QTC to the plant.  
  
 ===== List of Symbols ===== ===== List of Symbols =====
slice/qt.txt · Last modified: 2023/08/11 15:53 by 127.0.0.1