Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
| slice:qt [2019/05/17 19:51] – Michael Radunsky | slice:qt [2019/05/17 19:59] – [Interface Connections] Michael Radunsky |
|---|
| </tabcaption></WRAP> | </tabcaption></WRAP> |
| <WRAP center round box 60%> | <WRAP center round box 60%> |
| | {{ :warning-sign.png?100&nolink }} | Do not have servo loop engaged when connecting Servo Output to your plant. | | | {{ :warning-sign.png?100&nolink }} | Do not have servo loop engaged when connecting Servo Output to your plant. | |
| | {{ :warning-sign.png?100&nolink }} | It is suggested to not ground the cable shield at the transducer end of the interface cable as ground loops may be formed, degrading performance. | | | {{ :warning-sign.png?100&nolink }} | Use caution grounding the shield (drain) at the transducer end of the interface cable as ground loops may be formed, degrading performance. Consider floating the plant or not connecting the shield to the plant chassis. | |
| </WRAP> | </WRAP> |
| |
| You may purchase more cables separately from Vescent Photonics. We do not recommend making cables, but if you do so, make sure the metal sleeve is well grounded to provide proper shielding to the signal cables. | You may purchase more cables separately from Vescent Photonics. We do not recommend making cables, but if you do so, make sure the metal sleeve is well connected to the connector ground to provide proper shielding to the signal cables. |
| |
| ===== Operating the SLICE-QTC ===== | ===== Operating the SLICE-QTC ===== |
