Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
slice:dhv [2020/05/25 21:39] – [Using the Host GUI] Kurt Vogel | slice:dhv [2020/08/07 22:28] – [Setting the Voltage Limit] Michael Radunsky |
---|
The user can set the maximum voltage output on a given channel so as not to exceed the rated maximum for their device. From the Home screen, touch the CH 1 (or CH 2) field to see <imgref CH_settings>. Touch the Voltage Limit [V] field to set the maximum voltage output. The bar graph output indicator on the Home screen will scale automatically with the maximum voltage set point. \\ | The user can set the maximum voltage output on a given channel so as not to exceed the rated maximum for their device. From the Home screen, touch the CH 1 (or CH 2) field to see <imgref CH_settings>. Touch the Voltage Limit [V] field to set the maximum voltage output. The bar graph output indicator on the Home screen will scale automatically with the maximum voltage set point. \\ |
| |
| | <WRAP important></WRAP> |This voltage limit circuit in the DHV hardware limits the voltage (including the modulation input) to the user defined limit when using the G=20 V/V mode. However, this hardware limit does not cap the modulation input in the G=1 V/V. Therefore, when operating in the G=1 V/V mode, if the user were to set the nominal voltage set point to the user-defined maximum voltage output point, the output with a +10 V modulation input would exceed the user-defined limit by 10 V | |
==== Setting the Bias Voltage ==== | ==== Setting the Bias Voltage ==== |
To set the bias voltage about which the SLICE-DHV will operate on a given channel, touch the DC Bias [V] field on the Home screen. Depending on the length of the touch, either a view similar to <imgref Vset_knob> allowing rotary knob input or a keypad similar to <imgref keypad> will be displayed. Set the nominal bias voltage. \\ | To set the bias voltage about which the SLICE-DHV will operate on a given channel, touch the DC Bias [V] field on the Home screen. Depending on the length of the touch, either a view similar to <imgref Vset_knob> allowing rotary knob input or a keypad similar to <imgref keypad> will be displayed. Set the nominal bias voltage. \\ |