Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision |
slice:dcc [2020/04/30 23:53] – [Laser and Photodiode Connections] Michael Radunsky | slice:dcc [2020/04/30 23:54] – [Laser and Photodiode Connections] Michael Radunsky |
---|
| |
| |
<imgcaption mon_pd|Wiring configuration for monitor photodiode>{{ :slice:dcc:anode_cathode_ground_monitor_pd.png |}}</imgcaption> | <imgcaption mon_pd|Wiring configurations for monitor photodiode>{{ :slice:dcc:anode_cathode_ground_monitor_pd.png |}}</imgcaption> |
==== Setting the Operation Mode ==== | ==== Setting the Operation Mode ==== |
The SLICE-DCC has two operation modes: Constant Current and Constant Power. The operation mode, as with most other operating parameters can be set independently for each channel. To toggle between Constant Current and Constant Power modes, from the Home screen, touch the window labelled either CH X Constant Current or CH X Constant Power. If the channel is in Constant Current Mode, you will be presented with the window seen in <imgref cc_param>. \\ | The SLICE-DCC has two operation modes: Constant Current and Constant Power. The operation mode, as with most other operating parameters can be set independently for each channel. To toggle between Constant Current and Constant Power modes, from the Home screen, touch the window labelled either CH X Constant Current or CH X Constant Power. If the channel is in Constant Current Mode, you will be presented with the window seen in <imgref cc_param>. \\ |